A Vox Repeat Percussion with additional tone and rate switches. The knobs control Rate, Depth and Volume. There is also an additional boost section added to the stock circuit for some extra output. Built on vero with Wima caps, metal film resistors, red LED, Daka-ware knobs and a gold hammerite finish.
For Benjamin in Australia.

A Vox Repeat Percussion clone on vero. This one has a tone switch to allow for more bass through the circuit (the stock setting cuts some low end) and another toggle to switch between two rate ranges. There’s also an additional boost stage with a Volume knob to set the output level, as well as the usual Rate and Depth knobs. It uses Wima caps and BC electros with metal film resistors, a blue ultrabright LED and silver hammertone finish.
For Paul in the U.K.

A Vox Repeat Percussion clone on vero. This one has a tone switch to allow for more bass through the circuit (the stock setting cuts some low end) and another toggle to switch between two rate ranges. There’s also an additional boost stage with a Volume knob to set the output level, as well as the usual Rate and Depth knobs. It uses Wima caps and BC electros with metal film resistors, a white LED and silver hammertone finish.
For Alex in Dublin.

A clone of the Vox V809 Repeat Percussion with Depth and Rate controls. It also features a tone switch that goes between the stock tone and a more full range tone. The other toggle switches between two Rate ranges. There’s also a boost section which allows an output higher than the bypassed signal, which can be adjusted with the internal trimmer.
For Alessandro in Italy.

A Vox Repeat Percussion clone again using BC108/9 and 2N2646 transistors, Rate and Depth knobs with a Rate range switch, side-mounted jacks, yellow mini-curl knobs and a black hammertone finish.
For Finn of Ladydoll in Cork.

Another Vox Repeat Percussion clone with controls for Rate and Depth and a Rate range switch. Fitted with cream chicken-head knobs and finished in a black hammertone.
For Fabio in Spain.